Umbrella Dryer, 165' Line

Start air drying your laundry today with this umbrella clothesline outdoor dryer. This umbrella dryer consists of two parts - a galvanized steel pole and aluminum topper. To set up the dryer, the pole is secured in the ground with a ground sleeve. The collapsible aluminum top can then be unfolded and added to the pole. The top and steel post can be removed at will, so you can bring the clothesline inside during inclement weather. To install with ground sleeve included - dig a hole 8-12"" in diameter and 20"" deep. The hole should be wider at the bottom than at the top. Fill the hole with about 3"" of small rocks, then pour about 6"" of concrete into the hole or until concrete comes to the bottom of the ground sleeve when held flush with the ground. Holding the sleeve in place, finish filling the hole with concrete you may leave a small gap to fill in with dirt and grass if you wish. Immediately run a stick or tube through the sleeve and through the concrete to the rock base to allow water to drain. Insert the lower vertical pole of the dryer into the sleeve, then use a level to align the pole vertically. Remove pole and allow concrete to set fully, then install your dryer.